| Control Panel | PowerOn LEDdoesnot lightup/No display | PowerOn switch/MCB is not turnedON | Turnonthe PowerOn switch/MCB |
| | Thefuse is blown | Replace fuse |
| | Connection error | Make properconnection |
| MCB trip | Connection error& short circuit | Check the connections |
| Conveyor belt | Conveyor is notworking, butcan move by hand | Theconveyorbelt tension is toolow | Adjust the tension |
| | The conveyorbelt tension is too high | |
| Conveyor is notworking &cannot move by hand | Damaged gear | Replace the gear |
| | Thetension ofchain is too high | Adjust the tension |
| | Connection to motorisbroken | Check and correct connection |
| | Defective conveyor motor | Replace thedefective part |
| | The continuous pinis bad | |
| | Defective timer | |
| | Thejiggle switch isbad | |
| Film | Conveyor rollerdoes notmove | Defective conveyor motor | replace defective parts |
| | Defective conveyor motor | |
| | Defective motorbrake | |
| Filmisnot feeding properly | ImproperFilmloading | Correct it |
| Filmcan’t move | The tension shaftis noton level | adjust it |
| | Thepositionoftension roller is notproper | |
| | Thetriangular plate isnot properlyfixed | |
| | Thetension ofclamping chain istoo loose | adjust orlubricate |
| | Thetension ofclamping chain istoo tight | |
| Sealingbar | No performance | Opencircuits | Check thecircuit connections, replace defective parts &check theairpressure |
| | Defective electromagnet | |
| | Low airpressure | |
| Sealingblade doesnot heat up | Blown fuse | Replace fuse |
| | Defective cartridge heater | Replace part |
| | Defective timer | Replace the part |
| Temperature can‘t adjust | Defective temperature controller | Replace part |
| | Defective thermocouple | Replace thermocouple |
| | Open circuits | Correct the wire connections |
| Safety device does not work | Jiggle switch isbroken | Replace part |
| Can’t seal by manual mode | Openwires | Replace part |
| | Jiggle switch isbroken | |
| | Defective timer | Replace timer |
| | Insufficient airpressure | Inspect air sourceand Correct it |
| Improper sealing | Defective sealing blade | Replace it |
| | Settemperature is low | adjust it |
| | Setsealing timeis low | Increase thesealing time |
| | Airpressure is low | Inspect air sourceand Correct it |
| | Defective heater | Replace it |
| Waste film reclaim | Clamping chaindoes notmove | Open circuits | Correct them |
| | Themotordefective | Replace motor |
| | Defective brake | Adjust brake |
| | Continuous pin is broken | |
| | Thechain is tootight | adjust it |
| | Thenchain istoo loose | Adjust |
| | No lubrication | lubricate |
| Reclaiming wheel doesn’twork | Open circuits | Correct connection |
| | Themotordefective | replace spare parts |
| Imperfect sealing | | Thevoltage is toolow | Inspect thevoltage and correct it |
| | Incorrect timersetting | Replace it |
| | Connection errors | Correct it |
