| 1 | Machine doesn’t work/Power onLED doesn’t light up/No display | 1.No ACsupply. 2.Fuse blown/MCB tripped. 3.Mains cordfailure. 4.No control transformer output. | 1.Restore ACsupply. 2.Check for anyshort circuit or replace the fuse/reset the MCB. 3.Replace mainscord. 4.Check the voltages & replace itif defective. |
| 2 | Conveyor is not working andcan moveby hand | 1.Conveyor belt tension maybe too high/low. 2.Defective capacitor ofmotor. | 1.Adjust the tension. 2.Replace the capacitor. |
| 3 | Conveyor is not working andcannot moveby hand | 1.Conveyor belt tension is toohigh. 2.Defective motor. 3.Damagedgear. 4.Defective limit switch. 5.Defective relay inthe relay PCBA. | 1.Adjust the tension. 2.Check themotor connection for any breakage andreplace it if defective. 3.Replace it. 4.Replace the switch. 5.Check therelay output fromthe PCBAandreplace itif defective. |
| 4 | Film feeding is not doing/Film roller is notmoving | 1.Defective limit switch. 2.Defective motor/Capacitor. 3.Defective motor brake. 4.Defective relay inthe relay PCBA. 5.The tension shaft is notonthe level. 6.The position of tension roller is notproper. 7.The triangular plate is not properly fixed 8.The tension of clamping chain is tootight or loose. | 1.Check the connections andreplace it if defective. 2.Replace the defective part. 3.Replace it. 4.Check and replace the defective. 5.Adjust it. 6.Adjust it. 7.Adjust it. 8.Adjust or lubricate it. |
| 5 | Machine doesn’t seal/Improper sealing | 1.Low air pressure. 2.Defective cartridge heater. 3.Defective relay inthe relay PCBA. 4.Fuse blown. 5.Defective temperature controller/ temperature sensor. 6.Voltage is toolow. 7.Incorrect parameters settings. 8.Defective sealing blade. 9.Defective teflon tape. 10.Defective limit switch. 11.Defective SSR. | 1.Check and correct it. 2.Check for anyopencircuit and replace it if defective. 3.Check andreplace the defective. 4.Refcase2 ofcomplaint1. 5.Replace the defective part. 6.Check thevoltage. 7.Adjust the parameters as per film andproduct. 8.Replace it. 9.Replace them. 10.Replace it. 11.Replace it if defective. |
| 6 | Error messages doesn’t work properly | 1.Openconnections. 2.Defective limit switch. 3.Misaligned sensor/ Defective sensor. | 1.Check and doproper connections. 2.Check and replace if defective. 3.Adjust the position/Replace itif defective. |
| 7. | Waste film collection system is notworking properly. | 1.Poor quality film. 2.Defective motor/Capacitor. 3.Incorrect alignment ofguiding rollers. | 1.Use quality film. 2.Replace the capacitor/motor. 3.Adjust the guiding rollers adjacent to the outer conveyor. |
