13. MAINTENANCE

  1. 3. Clean the cutter with a clean cotton cloth. Do not use any metal or any hard object to clean the
  2. 1. Check the oil level in the FRL unit. If low, refill it.
  3. 2. Check the tightness of bolts and nuts. If loose. Tighten them properly.
  4. Pressed emergency switch
  5. Reset emergency switch
  6. Micro switch isn’t at right position
  7. Adjust micro switch position
  8. Defective micro switch
  9. Replace micro switch
  10. Pushing micro switch defective
  11. Seal bar level sensors not at correct position
  12. Set seal bar sensors to correct position
  13. The film does not seal and cut off
  14. Sealing temperature set low
  15. Increase the set temperature
  16. Sealing blades should be 0.4-0.5 mm above the bottom level of cutting blade. Adjust properly