8. Power connection

  • Power connection

10. Starting the machine

  • Starting the machine
  • 11.
  • Shut down/switching off

12. Shrinking operation

  • Shrinking operation

8. POWER CONNECTION

  • Green/Gray-Earth. Switch on the MCB. Turn on the blower fan and ensure that it spins anticlockwise, if not interchange any 2 phase after the motor become idle.

9. CONTROL PANEL

  • Conveyor speed control knob
  • Power LED
  • Control buttons
  • LCD 16x2 display

10. STARTING THE MACHINE

  • SET button
  • STOP button
  • To start the machine, connect the machine to appropriate power supply and switch on.
  • A LCD check function is done first; version of the software is displayed.
  • SHRINK TUNNELS
  • Sevana’s micro-processor based shrink tunnel machine has 4 preset modes or programs. Each program can be set with different parameters.
  • Temperature represents the temperature to be set in shrink chamber in degree Centigrade (°C). Speed represents the speed of conveyor (Minimum-maximum = 0-7.5 Meters per minute). Parameter values 0-20.
  • Select the mode by pressing “MODE” button.

12. SHRINKING OPERATION

  • 1. Special plastic films which shrink on application of heat are used for shrink wrapping. Shrink films
  • 2. Insert the article in a preformed sleeve or tube of shrinkable film of suitable size. Seal the open ends.
  • 3. Place the wrapped article on the conveyor at the inlet. The article will come out of the outlet properly
  • CHECK TEMPERATURE
  • SAFE TO TURN OFF