9. Installation

  • Filling vacuum pump with oil

12. Starting the machine

  • Starting the machine

8. CONTROL PANEL

  • LCD display
  • Control buttons

9. INSTALLATION

  • Open the back door & fill vacuum pump oil.
  • Connect plug to a single phase power socket .
  • Switch on the MCB & then press power button on the front panel.
  • Select MODE & set parameters (vacuum level, sealing time & cooling time) as per product & pouch.
  • Shutdown process: switch off the MCB.

10. FILLING VACUUM PUMP WITH OIL

  • There is no vacuum pump oil in the newly delivered machine. If the vacuum pump works without oil it will damage the pump, even in a short time. Please make sure that the vacuum pump has been filled with the oil up to the mark before the start-up.
  • Open the back cover.
  • Fill the machine with Sevol V/equivalent vacuum pump oil(500ml).
  • Check the oil level is between 1/2 and 3/4 of the oil level indicator. If it is less than 1/2, please add more.
  • If the oil level is between 1/2 and 3/4 of the oil level indicator then close the cap and fix the back door.

11. PROGRAM MODES

  • Sevana’s micro-processor based vacuum machine has 4 preset modes or programs. Each program can be set with different parameters. Variable parameters in each mode are
  • Vacuum level
  • 0-760mm Hg( Vacuum level in the chamber)
  • Vacuum levels represents in millimeter mercury up to vacuum has to be achieved (-760mmHg absolute vacuum, 0 is normal atmospheric pressure).
  • USING ONLY VACUUM:
  • If only vacuum is required, select MODE 4 by pressing the “MODE” button.
  • Select the mode by pressing “MODE” button. To set the parameters press “SET” button.
  • To change the vacuum press the “UP” or “DOWN” button continuously till the required value is displayed.

12. STARTING THE MACHINE

  • Stop/Reset
  • Set
  • A LCD check function is done first. Version of the software is displayed.
  • VACUUM LEVEL
  • Now the lid is closed, then vacuum increases up to the preset level.
  • After that the lid open automatically and the display changes to “ready mode”.
  • Press the “STOP” button for 1 second.

13. OPERATION

  • Switch on the supply
  • Adjust the vacuum and other parameters
  • Select the required mode
  • Close the acrylic lid and press gently, the vacuum pump starts automatically evacuating the whole chamber till
  • the set pressure is reached
  • opens automatically. All operations will be displayed on the display when they take place.