User Manual for QS4020ISTV&ISTVTV1

Fix the horizontal channel to the vertical legs with nuts and bolts provided along with the machine.
Place the chassis on the vertical leg assembly gently. Please ensure the corners are approximately aligned for ease of assembly.
The leveling screws can be adjusted for leveling the machine and to adjust the height of machine slightly
Before starting the machine please ensure that,

Blue to Phase3, Black to Neutral and Gray/Green to Earth. Then switch on the MCB

To start the machine, connect the machine to appropriate power supply and switch on the MCB. The MCB is located at the right side of the machine. Then switch ON the heater switch. The conveyor speed is adjusted using the knob present on the panel board. The temperature require...
LED on temperature controller turns off. Now the machine is ready for use.

Special plastic films which shrink on application of heat are used for shrink wrapping. The temperature required for shrinking each film varies and this information can be obtained from the film manufactures.
Shrink films commonly available are,
Insert the article in a preformed sleeve or tube of shrinkable film of suitable size. Seal the open ends & make a few holes on the film by pricking it with a pin. The corners of the film may also be sealed cut off for better appearance. If open ends are desired, the ends of th...
Place the wrapped article on the conveyor at the inlet. The article will come out of the outlet properly shrunk. Inspect the article.
If POF or PVC film used, to avoid the conveyor rod marks on the product then adjust the conveyor rod support so that conveyor rod support will fret conveyor rods and the rod will rotate.
Shrink film

Documents