9. INSTALLATION

  • 3. Before starting the machine please ensure that,
  • Heater Switch
  • To start the machine, connect the machine to the appropriate power supply and switch on the MCB. The MCB is located at the right side of the machine. Then switch ON the heater switch. In the speed controller, set the switch to the “RUN” position.The conveyor speed can be adjus...
  • QS4525DSTV User manual temperature is reached, the red indication LED on the temperature controller turns off. Now the machine is ready for use.

14. SHRINKING OPERATION​

  • Special plastic films which shrink on application of heat are used for shrink wrapping. The temperature required for shrinking each variety of film varies. This information can be obtained from the film manufacturer. Shrink films commonly available are,
  • Insert the article in a preformed sleeve or tube of shrinkable film of suitable size. Seal the open ends and make a few holes on the film by pricking it with a pin. The corners of the film may also be sealed and cut off for better appearance. If open ends are desired, the ends...
  • Place the wrapped article on the conveyor at the inlet. The article will come out of the outlet properly shrunk. Inspect the article.
  • If POF or PVC film are used, to avoid conveyor rod marks on the product, adjust the conveyor rod supports so that conveyor rod support will fret the conveyor rods and the rods will rotate.