5. Installation

  • Filling vacuum pump with oil

10. Starting the machine

  • Starting the machine

5. INSTALLATION

  • Ensure that there is no inflammable & explosive gases around.
  • Then open the back door & fill vacuum oil.
  • Give single phase power, switch on the MCB & then press power button on the front panel.
  • Set parameters (vacuum level, flushing level, sealing time & cooling time) as per product & pouch.
  • Shutdown process: switch off the MCB.

6. FILLING VACUUM PUMP WITH OIL

  • There is no vacuum pump oil in the newly delivered machine. If the vacuum pump works without oil it will damage the pump, even in a short time. Please make sure that the vacuum pump has been filled with the oil up to the mark before the start-up.
  • Open the back cover.
  • Fill the vacuum pump with Sevol V/equivalent vacuum pump oil.
  • Check the oil level is between 1/2 and 3/4 of the oil level indicator. If it is less than 1/2, please add more.
  • If the oil level is between 1/2 and 3/4 of the oil level indicator then close the cap and fix the back door.

8. CONTROL PANEL

  • LCD display
  • Control buttons
  • Power LED
  • MCB 16A/1 pole

9. PROGRAM MODES

  • Sevana’s micro-processor based vacuum machine has 4 preset modes or programs. Each program can be set with different parameters. Variable parameters in each mode are
  • Vacuum level
  • 0-760mm Hg( Vacuum level in the chamber)
  • Vacuum levels represents in millimeter mercury up to vacuum has to be achieved (760mmHg absolute vacuum, 0 is normal atmospheric pressure).
  • Select the mode by pressing “MODE” button
  • To set the parameters press “SET” button.
  • To change the vacuum press the “UP” or “DOWN” button continuously till the required value is displayed.
  • To select the next parameter and save the preset value press SET again.

10. STARTING THE MACHINE

  • Connect the machine to appropriate power supply. Turn on the power switch to start the machine. The power switch locates at the right side of the machine. Turn the power switch to the position 1 to start-up.Then press the power button in the control panel.
  • Stop/Reset
  • Set
  • A LCD check function is done first. Version of the software is displayed.
  • VACUUM LEVEL
  • Now the lid is closed, then vacuum increases up to the preset level.
  • VACUUM ERROR: OFF
  • After that the lid open automatically and the display changes to “ready mode”

11. OPERATION

  • Switch on the supply
  • Adjust the vacuum and other parameters
  • Select the required mode
  • Insert the product into the film pouch and then place it in the vacuum chamber in such a way that the open
  • Close the lid.