10. Setting up the machine for operation

  • Setting up the machine for operation

11. Film roll mounting

  • Film roll mounting

12. Operation

  • 13.
  • Collection of waste film
  • 14.
  • Microcontroller settings

9. CONTROL PANEL

  • Power On/Off switch (MCB)
  • Bridge ON/OFF switch

10. SETTING UP THE MACHINE FOR OPERATION

  • is 6Kg/ Sq.Cm. Also ensure that both power sources are of the required capacity of the machine.
  • machine is better than 100 MΩ at 500 V DC. Remove the shorting and connect the electric power with sufficient current carrying capacity cable from a suitably rated switch fuse unit or MCB outlet. Connect the pneumatic supply.
  • 3. Turn on the power switch. The POWER ON LED will be light up.
  • 5. Set the sealing temperature to required value.
  • 6. Select the preset mode. Set the sealing time and product advance values.
  • 7. Adjust the height between the film guiding triangular plates (21 & 22) for the object to
  • 8. Load the shrink film on the film support rollers and guide the film as per the route as
  • 9. Adjust the guide on the conveyor as per the size of the object to be packed.

11. FILM ROLL MOUNTING

  • Switch off the machine during the mounting of the film and setting it up to avoid any injuries.
  • i. Put film roller on the two supporting rollers.
  • turning plates, spreading on to that and making a 45 degree turn such that the inside of the film becomes out side and pull it further and clamp as shown in the diagram.

12. OPERATION

  • 1. Switch on the machine.
  • Set the temperatures of the sealing jaws depending on the type and thickness of film.
  • 3. Set the sealing time and product advance time in preset/mode. The recommended
  • 4. Set the distance between the sealing line and the end of packing.
  • 5. Adjust the distance between the triangular plates to match with the height of object to
  • 6. After the set temperature has reached, pack a few packets by the manual mode.
  • Shrink the samples. If required, alter the settings for the best results.
  • 7. After the final adjustments and trials, put the machine on auto mode and start

14. MICROCONTROLLER SETTINGS

  • Preset mode/program can be selected by pressing the MODE/RESET switch.
  • In the automatic modes we can set two parameters.
  • If the air pressure is too low to seal:
  • If the emergency stop button is pressed:
  • Correct the error and press the MODE/RESET button to continue.
  • CHECK & RESET
  • EMERGENCY STOP