9. Setting up the machine for operation

  • Setting up the machine for operation

10. Film roll mounting

  • Film roll mounting

11. Operation

  • 12.
  • Microcontroller settings

8. CONTROL PANEL

  • Power on/off switch (MCB)

9. SETTING UP THE MACHINE FOR OPERATION

  • 2. Sealing jaw is pneumatically operated. Use 8mm PU tube to connect compressed air supply of 6Kg/cm2 to
  • FRL(Filter Regulator Lubricator) provided with the machine & regulate the air pressure.
  • 3. Release the Emergency stop button.
  • 4. Turn on the MCB.
  • 5. Press the power switch LCD will be light up.
  • 7. Set the sealing time and temperature.
  • 9. Load shrink film on film support rollers and guide the film as per diagram shown.
  • 10. Adjust the height between film guiding triangular plates and guide on the conveyor as per the product.

10. FILM ROLL MOUNTING

  • Switch off the machine during the mounting of the film and setting it up to avoid any injuries. i.Put film roller on the two supporting rollers. ii.Release the film perforator by turning 90 degrees. iii.Pull the film and pass it as per the drawing given below. iv.Engage the fi...

11. OPERATION

  • 1. Switch on the machine.
  • 2. Set the temperatures of the sealing jaws depending on the type and thickness of film.
  • 3. Set the parameters.
  • 4. Set the distance between the sealing line and the end of packing.
  • 5. Adjust the distance between the triangular plates to match with the height of object to be packed. It is
  • 6. After the set temperature has reached, pack a few packets by the manual mode. Shrink the samples. If
  • 7. After the final adjustments and trials, put the machine on required mode and start continuous operation.

12. MICROCONTROLLER SETTINGS

  • Modes can be selected by pressing the MODE switch.
  • This mode can be used for to seal more than one product in a single sealing.
  • Press Feed/Seal
  • In the H sensor mode we can set,
  • In the Sensor Time mode we can set,
  • In the Timing mode we can set,
  • If the air pressure is too low to seal:
  • If the emergency stop button is pressed: